info

Je hebt het minimaal aantal bereikt

Winkelwagen (0)

Er zijn nog geen producten in uw winkelwagen geplaatst.

Race Series

Weergave:


Bezig met laden...
 ORCA-BP1001-ETS-13.5T

Snel bekijken

(0)
Niet op voorraad
 ORCA-BP1001-ETS-13.5T

ORCA-BP1001-ETS-13.5T

(0)
€ 99,95

 OR-BP1001-13.5T-ETS

ORCA BP1001 Blinky Pro Brushless Speed Controller  (ETS APPROVED)

 ORCA-BP1001-REPAIR

Snel bekijken

(0)
Niet op voorraad
 ORCA-BP1001-REPAIR

ORCA-BP1001-REPAIR

(0)
€ 72,50

 ORCA-BP1001-REPAIR 17.5 SPEEDO

 Sunpadow Platin HV ULCG 6100mAh 7.6V 2S 140/70C LiPo (5mm, 237g)

Snel bekijken

Bestellen

 Sunpadow Platin HV ULCG 6100mAh 7.6V 2S 140/70C LiPo (5mm, 237g)

Sunpadow Platin HV ULCG 6100mAh 7.6V 2S 140/70C LiPo (5mm, 237g)

(0)
€ 85,95


Sunpadow Platin HV ULCG 6100mAh 7.6V 2S 140/70C LiPo (5mm, 237g)

1:10 Brushless Set Dragster Turbo 2500KV RHI/Carson

Snel bekijken

Bestellen

(0)
Op voorraad
1:10 Brushless Set Dragster Turbo 2500KV RHI/Carson

1:10 Brushless Set Dragster Turbo 2500KV RHI/Carson

(0)
€ 79,95

Tamiya Cup Controller NL 1:10 Brushless Set Dragster Turbo 2500 KV, waterdicht 2/3S
Deze brushless set is speciaal gemaakt voor de Tamiya Cup NL en wordt gebruikt in de Top Stock klasse.

Natuurlijk is deze set ook te gebruiken voor andere auto´s als die in de Tamiya Cup worden ingezet.
De set is passend voor alle vaartuigen welke een 540er maat motor gebruiken.
Als je je auto wil sneller wil maken d.m.v. een 3S accu denk dan aan je overbrenging. (Tandwielverhouding).

Regelaar:
- Accutype: 2S en NiMH (6 cellen) ON-Road en OFF-Road, 3S en NiMH (9 cellen) Off en ON-Road.
- Continue stroom: 60A
- Piekstroom: 360A
- BEC-uitgang: 2A/5V
- Weerstand: 0,0007 Ohm
- Afmetingen: 51x36x36mm
- Gewicht: 80g

Programmeren van de regelaar kan o.a. via de programmeerkaart. Artikelnummer: C906303

- Motortype: Sensorloos
- KV (RPM/Volt): 2500KV
- Watt: max. 756W
- Max. Spanning: tot 12V
- Max. Stroomsterkte: 66A
- Min. stroom 3,2A
- Polen: 4
- Aansluiting: 4mm goud
- Diameter motoras: 3.175mm
- Lengte motoras: 15mm
- Afmetingen: 35,8x50mm
- Gewicht: 148g

Leveringsomvang:
- 1 Set RHI Carson 1:10 Brushless Set Dragster Turbo 2500KV

1up Racing Blue O-Ring Grease

Snel bekijken

Bestellen

(0)
Op voorraad
1up Racing Blue O-Ring Grease

1up Racing Blue O-Ring Grease

(0)
€ 9,95

1up Blue o-ring grease is the perfect answer for the serious racer looking to get the most performance from their car. With it’s superior ability to reduce sliding friction, your shocks will feel smoother than ever. Perfect for use on diff o-rings and seals to provide long lasting smooth operation and helps prevent leaking!

1up Racing Competition Bearing Set - Xray X4

Snel bekijken

(0)
Niet op voorraad
1up Racing Competition Bearing Set - Xray X4

1up Racing Competition Bearing Set - Xray X4

(0)
€ 38,95

1up Racing Competition Bearing Set - Xray X4
Complete bearing set from 1upRacing for your Xray X4 touring car. This bearing set will bring the best quality and efficiency to your ride and you shouln`t wait to get your hands on them!
Features of the 1up Racing ball bearing sets:
  •  
  • Pre-Oiled with 1up Racing Clear Bearing Oil
  • Improves Overall Feel and Responsiveness
  • Improves Corner Speed
  • Reduces Drivetrain Resistance
  • Excellent Lifespan
  • Excellent Value
Pro Tip: "Even if you care about your bearings frequently, you must replace them from time to time. We cannot point out the perfect timing for changing all your bearings as this depends a lot on the frequency you are using your car in general. But when you are changing from outdoor to indoor season (or vice versa), it is always a good moment to refresh your car with some new bearings!"

1up Racing CV Joint Oil 8ml - Red

Snel bekijken

Bestellen

(0)
Op voorraad
1up Racing CV Joint Oil 8ml - Red

1up Racing CV Joint Oil 8ml - Red

(0)
€ 9,95

1up Racing CV Joint Oil 8ml - Red

1up Racing Pink Ball Diff Grease - 3g

Snel bekijken

Bestellen

(0)
Op voorraad
1up Racing Pink Ball Diff Grease - 3g

1up Racing Pink Ball Diff Grease - 3g

(0)
€ 9,95

1up Racing Pink Ball Diff Grease - 3g

Formulated with extensive testing from our Factory Drivers and made for modern high-grip indoor racetracks, we are excited to introduce 1up Racing Pink Ball Diff Grease! Our super tacky Ball Diff Grease gives you the on-power steering and high-speed stability needed to push your buggy with confidence and shave away at your lap times. Like all of our greases, 1up Pink is proudly Made in the USA and backed with the 1up Racing Guarantee – Love it or we’ll return it. Pick one up today!

Follow these instructions to build  a buttery-smooth diff that lasts!

Step 1) Clean the outdrives, diff rings, diff balls, thrust rings, thrust balls and diff screw with parts cleaner to ensure they are free of any machining oils or burrs.

Step 2) Apply 1up Pink to the outdrives and install the diff rings.

Step 3) Apply a heavy amount of 1up Pink to the diff rings and outdrive surface area as shown.

Step 4) Pack 1up Pink into the diff gear and install the diff balls.

Step 5) Build the thrust assembly with 1up Gold as shown.

Finish the diff assembly per your instruction manual and set to a very light tension that just allows the diff movement to engage. Wipe away and save any excess 1up Pink that squeezes out.

Break-in is crucial, allow 30-40 minutes to complete these steps. With the car on a stand and no tires installed, insert the tip of a wrench into either outdrive slot and push through to lock the diff movement on that side. Turn on the car and set your throttle center point so the transmission begins rotating slowly. The opposite outdrive should be spinning. After 2-3 minutes turn down the throttle trim so the outdrive stops spinning, switch the wrench to the other side and repeat.

After both sides have spun at a very light tension for 2-3 minutes each, stop the transmission, tighten the diff screw 1/4 turn and repeat. Gradually tighten the screw after each tension has been broken in until you reach the desired setting. Charge up the battery and run the car on track for 3-4 minutes. Adjust the diff if needed and you’ll be good to go!

1up Racing Servo Mounting Screws 4,0mm Thread - black (4)

Snel bekijken

Bestellen

(0)
Op voorraad
1up Racing Servo Mounting Screws 4,0mm Thread - black (4)

1up Racing Servo Mounting Screws 4,0mm Thread - black (4)

(0)
€ 15,95

1up Racing Servo Mounting Screws 4,0mm Thread - zwart (4)

Met de servoschroeven van 1upRacing kunt u uw stuur- of gasservo heel gemakkelijk en precies monteren. De schroefdraad heeft een lengte van 4 mm en de schroeven passen perfect in alle gangbare servo's op de markt. Een verschuiving van de servo bij een crash wordt voorkomen door deze schroeven van 1upRacing.

De 4mm schroeven zijn verkrijgbaar in zwart, blauw en oranje!


Technische specificatie
Schroeven / Hardware: Servo Schroeven / Shims

1up Racing Servo Mounting Screws 4,0mm Thread - bleu (4)

Snel bekijken

Bestellen

(0)
Op voorraad
1up Racing Servo Mounting Screws 4,0mm Thread - bleu (4)

1up Racing Servo Mounting Screws 4,0mm Thread - bleu (4)

(0)
€ 15,95

1up Racing Servo Mounting Screws 4,0mm Thread - blauw (4)

Met de servoschroeven van 1upRacing kunt u uw stuur- of gasservo heel gemakkelijk en precies monteren. De schroefdraad heeft een lengte van 4 mm en de schroeven passen perfect in alle gangbare servo's op de markt. Een verschuiving van de servo bij een crash wordt voorkomen door deze schroeven van 1upRacing.

De 4mm schroeven zijn verkrijgbaar in zwart, blauw en oranje!


Technische specificatie
Schroeven / Hardware: Servo Schroeven / Shims

1up Racing Servo Mounting Screws 4,0mm Thread - Orange (4)

Snel bekijken

(0)
Niet op voorraad
1up Racing Servo Mounting Screws 4,0mm Thread - Orange (4)

1up Racing Servo Mounting Screws 4,0mm Thread - Orange (4)

(0)
€ 14,50

1up Racing Servo Mounting Screws 4,0mm Thread - Orange (4)

Met de servoschroeven van 1upRacing kunt u uw stuur- of gasservo heel gemakkelijk en precies monteren. De schroefdraad heeft een lengte van 4 mm en de schroeven passen perfect in alle gangbare servo's op de markt. Een verschuiving van de servo bij een crash wordt voorkomen door deze schroeven van 1upRacing.

De 4mm schroeven zijn verkrijgbaar in zwart, blauw en oranje!


Technische specificatie
Schroeven / Hardware: Servo Schroeven / Shims

1up Racing Servo Mounting Screws 6,0mm Thread black 4)

Snel bekijken

(0)
Niet op voorraad
1up Racing Servo Mounting Screws 6,0mm Thread black 4)

1up Racing Servo Mounting Screws 6,0mm Thread black 4)

(0)
€ 15,95

1up Racing Servo Mounting Screws ,0mm Thread - zwart (4)

Met de servoschroeven van 1upRacing kunt u uw stuur- of gasservo heel gemakkelijk en precies monteren. De schroefdraad heeft een lengte van 4 mm en de schroeven passen perfect in alle gangbare servo's op de markt. Een verschuiving van de servo bij een crash wordt voorkomen door deze schroeven van 1upRacing.

De 4mm schroeven zijn verkrijgbaar in zwart, blauw en oranje!


Technische specificatie
Schroeven / Hardware: Servo Schroeven / Shims


Deze website gebruikt cookies om het bezoek te meten, we slaan geen persoonlijke gegevens op.
Accepteer geselecteerde cookies